|
| 1- CLEAN |
 |
Remove bindings and stomp pad from board. Wipe the board clean using the prep pad provided in the installation kit. Make sure to scrub the board well, removing all dirt and residue. |
| 2- STICK |
 |
Once your sticker is completely aligned, remove the backing from one end of the sticker and apply the edge of the sticker to the tip of the board. There is a cut in the backing at one end of the sticker that designates that end as the starting point. Once you have a smooth application of the end of the sticker, double check that the sticker is still aligned correctly over the board.
Roll up the remainder of the topsheet and slowly peel off the backing while applying the topsheet to the board. Smooth topsheet as you go with the scraper provided in the installation kit until the board is completely covered with your new Stynkboards topsheet. |
| 3- CUT |
 |
Using the boards sidecut as your guide, cut off the excess sticker with the razor provided in the installation kit. Cutting downward from above the sticker and pressing the razor against the sidecut works best. Begin by making a broad cut all the way around removing the majority of the excess sticker. To fine tune and clean up the edges, find the edge between the top sheet and the sidecut, place the tip of the razor n this edge and cut in a clan line for no more than ten inches. Use the tip of the razor to lift up and remove the excess. Continue making clean, straight cuts in small sections until your edges are perfect! |
|
